Peugeot 308 Key Fob Replacement
Peugeot's 308 might be catching on a bit but it's still eye-catching. It's not the most luxurious vehicle in its class, but it is a relaxing and civilised driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid whether the issue is ongoing or intermittent.
Water Damage
If you accidentally drop your key fob into an eddy, or it is soaked while kayaking, canoeing, rafting, or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in activities that expose it to excessive water.
It's also important to make sure the fob has completely dried out prior to opening it to use it again. If you detect any odors from the fob (such as industrial liquid or windshield washer fluid) This is a further sign that it has been submerged.
A wet circuit may cause the battery's charge to drain or even explode. If you're able to fish the 308 key fob of the water body it got stuck in it, flip the button side down and shake out as much water as possible before opening the case. Take the battery out, and then clean the circuit board with a cotton swab that is dipped in 90 percent alcohol.
Other reasons why your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module issues signal interference, or a malfunctioning chip. If none of these causes the reason, you may try resetting the system by disconnection of the battery at 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system that allows the driver to start the car from afar, warming up or cooling down the vehicle prior to stepping inside. This feature is extremely beneficial particularly during the cold winter months. Remote start systems may be stopped for a variety of reasons, including the dead battery in the coin-battery.
A coin-shaped battery that is found inside the key fob will last a time of two to four years, based on how often it's utilized and where it was purchased. The date of use will be displayed on the packaging or marked in the user's manual.
If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, clean the chip with a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If exposed to soapy or salty water, the chip might be fried and you will need to replace the key fob altogether.
If you're unsure whether the battery is damaged you can check its voltage using a multimeter attached to both the terminals for plus and minus. If the voltage is less than 12-13 volts, you need to replace the battery. Alternatively, you can try to reset the onboard computer by disconnecting the 12 volt battery for a short period of time, and reconnecting it in reverse order (positive cable first and then negative). The engine should then start.
Faulty Receiver Module
If you don't see "Key Detected", it could be that your receiver module is malfunctioning. It's the part that sends an indication to the car when your key fob is activated which also acts as an immobiliser. It also stops it from starting until the correct key is used.
This could be due to a range of causes, such as water damage or simply aging. If the chip inside your Peugeot 308 keyfob is damaged by dirty tap water it could be because the keyfob was in contact with it. In this situation, you'll need to take it out and thoroughly clean it with isopropyl or an electronic cleaner. Once the battery has dried then you can try again.
If the issue continues to persist, it's probably a good option to consult a local Peugeot specialist or locksmith. They can employ an instrument for diagnosing to pinpoint the problem and fix it.
It can be stressful to lose your Peugeot car key. A qualified auto locksmith can solve the issue in a matter of minutes. They can program your vehicle and cut a fresh, functioning key for you. Click here to find a locksmith near you.
A malfunctioning electronic chip
The electronic chip that is in your Peugeot 308 key fob is an important component of the remote control system. If the chip is damaged, you could encounter issues starting your car or get a message saying "anti-theft". In this instance the only option is to replace the key. Fortunately, auto locksmiths with experience can offer the service within the shortest period of time.
The chip in your Peugeot 308's key fob could fail due to different reasons, including water damage, sweat or dirt. If your Peugeot 308 key fob has been exposed to soapy water, clean it right away. You can clean the electronic component using paper towels soaked with isopropyl Alcohol. After that, allow the battery to dry completely.
Radio interference can cause the key fob's functionality to cease. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. shell could be caused by bad conditions or objects near to the vehicle. If you have this issue it is recommended to visit the Peugeot dealership.
The Peugeot 207/308 Key Fob is very delicate and requires special attention. It is imperative not to drop or throw the key fob. If you lose something, try to find it as soon as possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Disconnect the negative cable before the positive.